Eliminating Press F1 To Continue

Batrai cmos
One time when I reboot the computer turns the message "CMOS checksum error - Defaults Loaded. Press F1 to continue, F10 to enter setup ", why is this?, How klo that server unexpectedly exits press F1 to continue, any power failure or have to reboot the pc to the location only to pejet F1? Could have consumed us, may most people already know the problem, but still there are some who belom know what the problem is, this time helmstandart will try to share how his solution, so if we go gang .... do not forget to bring blankets wkwkwkwk
1. Most of the problems that occur in its BIOS failure caused the already weak battery BIOS / abis, the solution is changing its BIOS battery is the same as the model of battery hours, this BIOS battery can be said the same with batteries that cost JAM ga expensive at around 8000 to 4 heheheh .. cheap huh??

2. But if still belom could change / update ajah date and time contained in the BIOS on reboot still nya.dan finally wrote out press F1 to continue wkwkkwkw what? Quiet broo ...

3.coba go back into the BIOS settings section below
The floppy drive type (set to NONE)
Floppy drive seek - the bios looks for a floppy drive during the posting process (set to NO)
Halt On (set to NO ERROR)
nah deh klo already tried it on reboot should have no comeback tuh ..

4. Klo was the problem still exists the possibility of a faulty Power Supply broo that disrupts the electrical system, the solution is just to replace the power supply nya